Use and Care Manual

13
ROUTINE CLEANING
Before beginning any cleaning procedure, unplug the brewer to avoid the
accidental start of a brew cycle.
Clean the pod holder, drip tray and drip tray grate
after each use, using a damp cloth and mild detergent
and rinse. With the pod holder and drip tray removed,
use a damp cloth with mild detergent to wipe the
area below the pod holder and into the drip tray area.
Occasionally, wipe the outside of the brewer with a
damp cloth. (The reservoir, slide lid, pod holder, drip
tray and drip tray grate are dishwasher safe.)
PERIODIC CLEANING/DESCALING
(Recommended At Least Once a Month.)
Periodically, you should clean and descale the brewer to clear any
mineral deposits that may have accumulated due to impurities in the water
source. If these deposits are not removed, they can impair the operation of
the brewer and reduce the product life.
There are several products available specifically for descaling. We
recommend using URNEX
®
Activated Descaler or JavaClean2 Cleaner and
Descaler, available on our web site: www.bunn.com. (White vinegar can be
used to descale if a descaling product is not available.)
Follow the directions as printed on the manufacturer’s package.
1) Fill the reservoir with descaling product as described by the
manufacturer’s directions, or 1 quart (32 oz.) of
white vinegar. Do not add powder mix directly to
the reservoir. Descaling product must be mixed into a
solution before it is added to the reservoir.)
2) Place an empty pod holder into the brewer. Be
sure the holder is locked into place, and set the
VOLUME CONTROL SLIDE LEVER to the maximum
position. (12 oz.)
3) Place an empty cup or bowl on the drip tray grate
that will hold at least 14 oz. of liquid, and press the
COFFEE BREW BUTTON to start a brew cycle.
4) Once the brew cycle has finished, empty the cup
and set it back onto the drip tray grate. Press the
COFFEE BREW BUTTON again to start a second
brew cycle.
5) Once the brew cycle has finished, empty the
cup and the remaining solution, or vinegar from
the reservoir. Remove the Pod Holder; clean the
reservoir and pod holder thoroughly using a mild
detergent, then rinse.
NOTE: There is now descaling solution in the internal
tank. Follow the manufacturer’s directions if the
solution must be left in the tank for any period of
time. For vinegar, allow the solution to sit for at least
two, but no more that four hours.
6) Fill the reservoir to the maximum line with fresh
clean cold water and place the pod holder back into the brewer.
C
o
f
f
e
e
T
e
a
4
O
Z
.
5
6
7
8
9
1
0
1
1
1
2
O
Z
.
C
o
f
f
e
e
T
e
a
4
O
Z
.
5
6
7
8
9
1
0
1
1
1
2
O
Z
.
C
o
f
f
e
e
T
e
a
4
O
Z
.
5
6
7
8
9
1
0
1
1
1
2
O
Z
.
C
o
f
f
e
e
T
e
a
4
O
Z
.
5
6
7
8
9
1
0
1
1
1
2
O
Z
.
P2906
P2907
P2908
P2912