Use and Care Manual

18
TROUBLESHOOTING (Cont.)
SITUATION
EXPLANATION
The Pod Holder will not
come out of the brewer.
Water is appearing on the
counter around the base
of the brewer.
Water leaks out around
the sprayhead.
The pod in the POD HOLDER may have
swelled to a point where the holder does
not slide out easily.
Wait at least 10 minutes and then try
carefully removing the pod holder again.
CAUTION: Hot liquid may be present.
The WATER RESERVOIR has been
removed to be filled with water and was
not seated properly when it was replaced.
Remove the lid from the top of the
brewer. With firm, but not forceful
pressure, press down on both sides of
the reservoir to ensure that the seal in the
bottom of the reservoir seats properly.
Replace the lid and watch for additional
water around the base of the brewer. If
a problem persists, contact Customer
Service. (Refer to page 20 or 22 for
customer assistance.)
Replace a damaged seal or tighten a loose
sprayhead.
Refer to “Assembling The Sprayhead/
Seal” & “Inspecting The Sprayhead/Seal”
sections for detailed information on how
to resolve sprayhead leaks.
CAUTION: Wait for hot liquid to cool.