Use and Care Manual

ManualsBrandsBunn ManualsHousehold ApplianceMCU Single Cup Multi-Use Coffee Brewer

CORRECT

(Seal visible and

not obstructed)

INCORRECT

(Seal partially obstructed

by Sprayhead)

INCORRECT

(Seal behind Sprayhead)

reassembling the sprayhead

seal

If Sprayhead and Seal are separated during removal or cleaning, they must be reassembled

properly for My Café

brewer to function.

1. Identify the top of the Seal – it will have

rough ridges while the bottom is smooth

2. Identify the top of the Sprayhead – it has

a star pattern and a threaded hole where

the Sprayhead attaches to the brewer.

3. Guide the Sprayhead into the channel of

the Seal. Gently stretch the Seal if needed.

Make sure it is completely in the channel.

When properly assembled, the Sprayhead

will slide easily into the channel of the

Seal and will not cause any buckles in the

surface of the Seal.

CAUTION: Improper reassembly

could result in personal injury from

hot water.

CLEANING & MAINTENANCE

storing the brewer

Unplug the brewer and wait for it to cool. It must be stored above 40°F/4°C to prevent

damage to the internal Hot Water Tank. If you do not use your brewer for an extended

period of time, we recommend running two to three cycles of water through prior to

brewing coffee or tea.

NOTE: After Initial Set Up, water will remain in the internal Hot Water Tank.

cleaning water probes

There are two stainless steel Water Probes in the Pour-In Bowl that are designed to detect

if water is present. Minerals from the water you use may build up in the Pour-In Bowl and on

the probes and may cause the brewer to incorrectly read that water is in the Pour-In Bowl.

1. Unplug the brewer

and allow it to cool

(minimum 1 hour).

Then rotate the Spin

Lid open.

2. Remove the 2 screws

in the Pour-In Bowl

with a Phillips head

screw driver.

3. Remove top of the

Pour-In Bowl by lifting

the front edge up

slightly, sliding the lid

back to unhook it and

then lift off.

4. Gently scrub the Water

Probes and surrounding

area with a textured

sponge or a toothbrush

to remove deposits.

5. Replace top of Pour-In

Bowl by sliding

forward until rear catch

engages, then lower the

front of the lid.

6. Re-install the screws

to the Pour-In Bowl

lid. Perform Brewer

Maintenance as

directed on page 10.