Owner's Manual

ManualsBrandsBunn ManualsWater DispenserOHW

INITIAL SET-UP - H5M

CAUTION - The dispenser must be disconnected from the power source throughout the

initial set-up, except when speciﬁed in the instructions.

1. Remove the upper rear panel and rotate the control thermostat knob fully coun-

terclockwise to the “OFF” position and replace the panel.

2. Connect the dispenser to the power source and turn-on the water supply.

3. Water will automatically ﬂow into the tank to the proper level and shut-off. This

will take approximately 10 minutes.

4. Disconnect the dispenser from the power source, remove the upper rear panel

and place the control thermostat knob fully clockwise to the “ON” position, and

replace the panel.

5. Connect the dispenser to the power source and wait approximately twenty

minutes for the water in the tank to heat.

6. On models with ready indicator, the indicator will light up when the proper water

temperature is achieved.

INITIAL SET-UP - HW2

CAUTION - The dispenser must be disconnected from the power source throughout

the initial set-up, except when speciﬁed in the instructions.

1. Remove the center rear panel and rotate the control thermostat knob fully coun-

terclockwise to the “OFF” position and replace the panel.

2. Plug-in the dispenser.

3. Water will automatically ﬂow into the tank to the proper level and shut-off.

4. Unplug the dispenser, remove the center rear panel and rotate the control ther-

mostat knob fully clockwise to the “ON” position, and replace the panel.

5. Plug-in the dispenser and wait approximately twenty minutes for the water in the

tank to heat. The dispenser is ready for use.

INITIAL SET-UP - OHW

CAUTION - The dispenser must be unplugged throughout the initial set-up,

except when speciﬁed in the instructions.

1. Place an empty vessel under the faucet, lift the pour-in lid, and pour a full pitcher

(64 oz) of tap water into the top of the dispenser. Hold open the faucet handle

to allow air to escape from the tank while it is ﬁlling.

2. Pour another full pitcher into the top. Close the faucet when water starts ﬂowing

from the faucet.

3. Fill the top basin with additional water until it is approximately one inch from

the top lid.

4. Plug-in the dispenser and wait approximately 15 minutes for the water to heat

to the proper temperature.

5. The dispenser is now ready for use. (refer to the section on normal use.)

NORMAL USE

CAUTION - Water dispensed from this faucet is extremely hot . (Above 200° F.)

1. Hold open the faucet whenever a cup of hot water is desired.

2. Pour another full pitcher into the top whenever water is no longer available at

the faucet. No wait is needed, the faucet is ready to dispense another cup of

hot water.

NOTE - Due to the tank capacity and heater size, this product should be used only

for dispensing a few cups of hot water at a time. (Larger capacity Bunn-O-

Matic hot water dispensers are available.)

H5M

HW2

46819 043012

OHW