User's Manual

INTRODUCTION

This equipment dispenses granita-type and cold liquid drinks on demand from separate hoppers. Operating controls

are accessible only through password protection.

CONTENTS

Introduction & Warranty ................................................................................................ 3

Site Preparation, Electrical Requirements ...................................................................... 3

Initial Setup .................................................................................................................... 4

Operating Controls ......................................................................................................... 8

Using the Dispenser for Granita-Type Products ........................................................... 10

Using the Dispenser for Cold Liquid Products ............................................................. 10

Other Recommendations For Your Dispenser .............................................................. 11

Recommended Daily Cleaning ..................................................................................... 12

User Notices ................................................................................................................ 14

40563 041108

SITE PREPARATION

The dispenser is very heavy. Place it on a sturdy counter or shelf capable of supporting at least 180 lbs. It is

for indoor use only.

The dispenser must have at least six inches of space behind it. This space is needed for airﬂow, air ﬁlter

removal, and cleaning. A clearance of at approximately six inches is recommended between the dispenser sides

and the wall or another appliance. The dispenser performs better if not placed near any heating appliance. Leave

some space so the dispenser can be moved for cleaning.

ELECTRICAL REQUIREMENTS

CAUTION – Improper electrical installation will damage components. An electrician must provide electrical service

as speciﬁed below.

Model ULTRA-1 & 2, This dispenser has an attached cordset and requires a 2-wire, grounded, individual branch

circuit rated 120 volts ac, 15 amp, single phase, 60 Hz. The mating connector must be a NEMA 5-15R.

(Refer to the dataplate for exact electrical requirements.)

Model ULTRA-1A & 2A, This dispenser has an attached cordset and requires a 2-wire, grounded, individual

branch circuit rated 230 volts ac, 10 amp, single phase, 50 Hz. (Refer to the dataplate for exact electrical require-

ments.)

Model ULTRA-1B & 2B, This dispenser has an attached cordset and requires a 2-wire, grounded, individual

branch circuit rated 100 volts ac, 10 amp, single phase, 50 Hz. (Refer to the dataplate for exact electrical require-

ments.)

NOTE – Bunn-O-Matic does not recommend the use of any extension cord with these dispensers.