User guide

ManualsBrandsBurcam ManualsPumps300500 SUBMERSIBLE SUMP PUMP 1/3HP 115V

2190 Boul. Dagenais West TEL: 514.337.4415

LAVAL (QUEBEC) FAX: 514.337.4029

CANADA

H7L 5X9 info@burcam.com

INSTALLATION

INSTRUCTIONS

Your pump has been

carefully packaged at

the factory to prevent

damage during shipping.

However, occasional

damage may occur due to

rough handling. Carefully

nspect your pump

for

damages that could

cause failures. Report

any damage to your

carrier or your point of

purchase.

Please read these

instructions

carefully. Failure

to comply to

instructions and

designed

operation of

this system,

may void

the warranty.

MODEL

300500

SUMP PUMP

WWW.BURCAM.COM

Summary of content (6 pages)

PAGE 1
INSTALLATION INSTRUCTIONS W W W. B U R C A M . C O M 2190 Boul. Dagenais West LAVAL (QUEBEC) CANADA H7L 5X9 TEL: 514.337.4415 FAX: 514.337.4029 info@burcam.com MODEL 300500 SUMP PUMP Your pump has been carefully packaged at the factory to prevent damage during shipping. However, occasional damage may occur due to rough handling. Carefully inspect your pump for damages that could cause failures. Report any damage to your carrier or your point of purchase.
PAGE 2
SAFETY INSTRUCTIONS: This fine pump that you have just purchased is designed from the latest in material and workmanship. Before installation and operation, we recommend the following procedures: A B C D E CHECK WITH YOUR LOCAL ELECTRICAL AND PLUMBING CODES TO ENSURE YOU COMPLY WITH THE REGULATIONS. THESE CODES HAVE BEEN DESIGNED WITH YOUR SAFETY IN MIND. BE SURE YOU COMPLY WITH THEM.
PAGE 3
APPLICATION This submersible sump pump is designed for a permanent sump installation. For dewatering around homes and farms. It can be used in light commercial application. CAPACITY: 5’ 10’ 15’ 18’ 3000 2500 2000 1450 FEATURES  Non corrosive material.  Stainless steel mechanical rotary seal.  Thermal and overload protection.  Piggy back grounded cables.  115VAC, 60Hz. 4A (8.
PAGE 4
SUMP PUMP APPLICATION SEE DIAGRAM ON PAGE 5 STEP 3 At this step, you have the opportunity to install a 1 1/2” or a 1 1/4” discharge. We recommend a 1 1/2” ABS/DWV discharge. Install a check valve (350362 in-line 1 1/2” or 350363 1 1/2” MNPT inlet and 1 1/2” or 2” outlet or 350353 1 1/4” MNPT inlet and 1 1/4” or 1 1/2” outlet) over discharge pipe of your pump and secure it with stainless steel clamps or glued nipple for ABS/DWV pipe.
PAGE 5
SUMP PUMP APPLICATION STEP 3 Prepare your choice of discharge pipe size and check valve STEP 2 Sump pit 18” diameter X 25” depth STEP 6 Connect float and motor power cable STEP 7 STEP 5 Fill the basin and test the operation Install discharge pipe STEP 8 STEP 4 Review and check connections for leaks Install your pump in centre of pit REPAIR PARTS REF. PART DESCRIPTION 15 7 REF.
PAGE 6
TROUBLE SHOOTING GUIDE CHECKLIST NEVER MAKE ADJUSTMENTS TO ANY ELECTRICAL APPLIANCE OR PRODUCT WITH THE POWER CONNECTED. DON’T JUST UNSCREW THE FUSE OR TRIP THE BREAKER, REMOVE THE POWER FROM THE RECEPTACLE. TROUBLE PROBABLE CAUSE ACTION Motor does not run.