Manual

ManualsBrandsBurcam ManualsPumps300526 1/2HP 115V EFFLUENT PUMP VERTICAL SWITCH C.I. /S. STEEL

www.burcam.com

2190 Dagenais Blvd. West TEL: 514.337.4415

LAVAL (QUEBEC) FAX: 514.337.4029

CANADA

H7L 5X9 info@burcam.com

Your pump has been carefully packaged at the

factory to prevent damage during shipping. However,

occasional damage may occur due to rough handling.

Carefully inspect your pump for damages that could

cause failures. Report any damage to your carrier or

your point of purchase.

INSTALLATION

INSTRUCTIONS

MODEL

300526

EFFLUENT

PUMP

Please read these

instructions

carefully. Failure

to comply to

instructions and

designed

operation of

this system,

may void

the warranty.

Summary of content (6 pages)

PAGE 1
www.burcam.com 2190 Dagenais Blvd. West LAVAL (QUEBEC) CANADA H7L 5X9 INSTALLATION INSTRUCTIONS MODEL 300526 TEL: 514.337.4415 FAX: 514.337.4029 info@burcam.com Your pump has been carefully packaged at the factory to prevent damage during shipping. However, occasional damage may occur due to rough handling. Carefully inspect your pump for damages that could cause failures. Report any damage to your carrier or your point of purchase. EFFLUENT PUMP Please read these instructions carefully.
PAGE 2
SAFETY INSTRUCTIONS: This fine pump that you have just purchased is designed from the latest in material and workmanship. Before installation and operation, we recommend the following procedures: with your local electrical and A Check plumbing codes to ensure you comply with the regulations. These codes have been designed with your safety in mind. Be sure you comply with them.
PAGE 3
APPLICATION: FEATURES:  This submersible effluent pump is designed for a permanent installation for domestic use homes, cottages and farms.  Cast iron pump housing.  Multi-purpose effluent pump will fill the need in most sump applications.  Noryl vortex impeller, clog free type.  To pump water as a permanent installation pump.  1/2HP, 115VAC, 60Hz, 5A (10A at start).
PAGE 4
STEP 2 Assuming that you have a sump pit located in your basement floor... Your sump pit may be constructed from concrete, brick, tile or more recently a sump basin made from plastic and/or fiberglass. The minimum size of your sump pit should be 18” in diameter and no less than 5” deep. When pit is ready, proceed to next step. EFFLUENT PUMP APPLICATION (See diagram on page 5) STEP 3 At this step, you have the opportunity to install a 1 1/2” or a 1 1/4” discharge. We recommend a 1 1/2” ABS/DWV discharge.
PAGE 5
EFFLUENT PUMP APPLICATION STEP 3 Prepare your choice of discharge pipe size and check valve. STEP 6 Connect float and motor power cable. STEP 2 Sump pit 18’’ diameter X 25’’ depth. STEP 5 Install discharge pipe. STEP 7 Fill the basin and test the operation. STEP 4 Install your pump in center of pît. STEP 8 Review and check connections for leaks. REPAIR PARTS REF.
PAGE 6
TROUBLE SHOOTING GUIDE CHECKLIST NEVER MAKE ADJUSTMENTS TO ANY ELECTRICAL APPLIANCE OR PRODUCT WITH THE POWER CONNECTED. DON’T JUST UNSCREW THE FUSE OR TRIP THE BREAKER, REMOVE THE POWER FROM THE RECEPTACLE. TROUBLE PROBABLE CAUSE ACTION Motor does not run.