User Manual

ManualsBrandsBurcam ManualsHardware700310 WATER FILTRATION SYSTEM WITH REMINDER

2190 Boul. Dagenais Ouest TEL: 514.337.4415

LAVAL (QUEBEC) FAX: 514.337.4029

CANADA

H7L 5X9 info@burcam.com

INSTALLATION

INSTRUCTIONS

WWW.BURCAM.COM

MODEL

700310

WATER

FILTRATION

SYSTEM

Your system has been carefully packaged at the

factory to prevent damage during shipping.

However, occasional damage may occur due to

rough handling. Carefully

inspect your system

for damages that could cause failures. Report any

damage to your carrier or your point of purchase.

When required, contact our

customer service to order the

replacement filters.



SEDIMENT FILTER

# 700329



CARBON FILTER

# 700328

700328

700329

Please read these

instructions

carefully. Failure to

comply to instructions

and designed

operation of

this system,

may void

the warranty.

Summary of content (6 pages)

PAGE 1
INSTALLATION INSTRUCTIONS W W W. B U R C A M . C O M 2190 Boul. Dagenais Ouest LAVAL (QUEBEC) CANADA H7L 5X9 TEL: 514.337.4415 FAX: 514.337.4029 MODEL 700310 info@burcam.com Your system has been carefully packaged at the factory to prevent damage during shipping. However, occasional damage may occur due to rough handling. Carefully inspect your system for damages that could cause failures. Report any damage to your carrier or your point of purchase.
PAGE 2
SAFETY INSTRUCTIONS: This fine system that you have just purchased is designed from the latest in material and workmanship. Before installation and operation, we recommend the following procedures: CHECK WITH YOUR LOCAL PLUMBING CODES TO ENSURE YOU COMPLY WITH THE REGULATIONS. THESE CODES HAVE BEEN DESIGNED WITH YOUR SAFETY IN MIND. BE SURE YOU COMPLY WITH THEM. A DO NOT INSTALL THIS SYSTEM ON THE HOT WATER LINE. THIS WILL VOID WARRANTY.
PAGE 3
INSTALLATION STEPS First, it is mandatory to cut-off the water supply for this application. Specifications: maximum water hardness should not exceed 10 PPM at pH 6.9. For water with hardness greater then 10 PPM at pH 6.9, the use of a water softener is recommended or the lifespan of the cartridge will be reduced tremendously. STEP 1 We recommend that you install your dispenser in a location where there is adequate room for servicing at a later date.
PAGE 4
STEP 6 Gasket PHOTO 2 Install the faucet as illustrated (photo 2). STEP 7 Connect the flexible pipe, from system meter to the faucet. (photo 3) Teflon tape PHOTO 3 Insert Pressure seal Rigid washer Lock washer Flexible washer Coupling ring STEP 8 Adjust the meter to 6000 litres, turning the knob clockwise. Align with the arrow (photo 4). STEP 9 Open the gate valve to allow water supply into the system. PHOTO 4 STEP 10 Open the filtration system faucet until suitable flow.
PAGE 5
FILTER REPLACEMENT REPAIR PARTS THE DECISIVE FACTORS Water consumption is the most important factor that determines life span of the system components. In addition, you should consider: - Water hardness. - Water pipe quality. - Unuse period of the system. 11 1 2 3 4 Your system has a water meter to help you to determine filter replacement time. Note that if you detect impurity, taste and odor, you should proceed to replace the cartridges.
PAGE 6
TROUBLE SHOOTING GUIDE CHECKLIST TROUBLE PROBABLE CAUSE Tiny black particles in water Cloudy water and bubles. Taste and odor Reduced flow Leaks ACTION New cartridges contain activated carbon it is an inoffensive powder. Open system faucet to purge particle, until water is clear. Air in the system, after installation Drain the system carefully. The cartridges do not retain chlorine from water. Replace both cartridges. Filter is equipped with flow restrictor. A moderate flow (approx.