User's Guide

E247 - DRO T4
29/06/2021
Built from CF032 V2.0
Page 4 of 5
Technical Construction File
CONFIDENTIAL – PROPRIETARY INFORMATION
FCC & IC Instructions
List of applicable FCC rules
The module has been tested following FCC 47 CFR part 15.245 and RSS-210.
Summarize the specific operational use conditions
The module is considered as a field disturbance sensor. It will be used as doppler sensors to detect
low speed moving targets (such as pedestrian, vehicules,…) in industrial environment.
The module must be installed and used in strict accordance with the manufacturer’s instructions as
described in the user documentation that comes with the product.
Power supply of the module must be conform to the electrical specifications as described in §
“Technical characteristics” of the current user manual.
Limited module procedures
Not applicable
Trace antenna designs
Not applicable
RF exposure considerations
Applicable conditions:
The module is made to be used in fixed applications.
The following information is required to be incorporated in the user manual of the final system:
- This device has been tested and approved to comply with FCC 47 CFR part 15.245 and
RSS-210
- The antenna of the module may not be removed, replaced nor modified. The antenna must
not be co-located or operating in conjunction with any other antenna or transmitter. No
additional antenna must be used.
- This device may not cause harmful interferences, and this device must accept any
interference received, including interference that may cause undesired operation.
Antennas
The module has build-in antennas. Modification on the antenna can not be operated and no
additional antennas can be used.
Label and compliance information
A label with the words ‘Contains FCC ID:G9B-100606’ and ‘Contains IC:4680A-100606’ shall be
applied and visible from the outside of the end product.
Information on test modes and additional testing requirements
Not applicable
Additional testing, Part 15 Subpart B disclaimer
Changes or modifications made to the equipment not expressly approved by BEA Inc. may void the
FCC & IC authorization to operate this equipment.