Owner manual

Installation and wiring

Type 8012

Correct

Incorrect

Fluid circulation

direction

Fig. 6 : Air bubbles within the pipe

Correct

Incorrect

Correct

Incorrect

Fig. 7 : Filling the pipe

7.2.2. Installing a device with welding

ends

note

The SE12 electronic module and the seal may be damaged

when welding the connections to the pipe.

• Before welding to the pipe, unscrew the 4 locking screws on

the SE12 electronic module.

• Remove the electronic module.

• Remove the seal.

→ Follow the installation recommendations in chap. 7.2.2.

→ Weld the connections.

→ After welding the connections to the pipe, correctly replace the

seal.

→ Properly replace the electronic module.

→ Tighten the 4 screws in an alternating pattern, applying a torque

of 1.5 Nm.

English