Owner manual

29
Installation and wiring
Type 8012
7.2.3. Installing a device with Clamp
connections
→ Follow the installation recommendations in chap. 7.2.1.
• Check that the seals are in good condition.
• Place the seals, that have been chosen depending on the
process temperature and fluid, into the grooves of the
Clamp connections.
→ Fit the Clamp connections to the pipe using a clamping collar.
7.2.4. Installing a device with flange
connections
→ Follow the installation recommendations in chap. 7.2.1.
• Check that the seals are in good condition.
• Insert a seal, that has been chosen depending on the
process temperature and fluid, into the grooves of the
connections.
Make sure the seal remains in its groove when tightening
the flange.
→ Tighten the flange to mount the device to the pipe.
English