User Manual

Replacement instructions
Instructions de remplacement
1310/1_EU-ML_00555960
→ On a compact version, loosen the 2 screws
and pinch each of the 2 supports that attach
the electronic board to the cover.
Screws
Supports
→ Carefully remove the electronic board from the cover.
→ Make sure the supports are not damaged. If at least one support is damaged, replace the cover.
→ Loosen the terminal screw marked «PE» and remove the wire from the terminal. See figure below.
→ Pinch one of the 4 spacers that attach
the basic board to the protection board.
→ Make sure not to touch the electronic
components and slightly pull the pro-
tection board.
→ Make the previous 2 steps for the other
3 spacers.
→ Remove the protection board.
«PE» terminal
Spacers
Spacers
→ Make sure not to touch the electronic
components and remove all the spacers
from the basic board.
Spacers
Spacers
→ Replace the defective board(s).
→ Turn the boards in the correct position and insert the protection board on the basic board.
→ Insert the «PE» wire into the terminal marked «PE» then tighten the terminal screw.
→ Turn the board to position the display on the cover window and insert the assembled electronic board into the
cover.
→ On a compact version, tighten the 2 screws of teh electronic board to attach the eletronic board to the
housing.
→ Wire the device according to the Operating Instructions.
Typ 8025/8035