User Manual

25
Installation and wiring
→ To cut the opening in the cabinet door, use the supplied drilling jig, respecting the dimensions indicated in
“Figure 11”.
95
80
76
50
95
80
76 50
Figure 11: Dimensions of the drilling jig [mm]
→ Insert the 4 screws in the housing (from the front).
→ Insert the seal on the external threads of the 4 screws (rear of the housing).
→ Put the assembly on the cutout, electronics turned to the inside of the cabinet.
→ Put the 4 washers on the 4 screws.
→ Put a nut on each of the 4 screws and tighten the nuts to secure the device to the cabinet.
Seal
Nut
Washer
Screws
Cable clip
Figure 12: Installation of a 8025, panel version
English
Type 8025 - 8035 BATCH