Manual

23
INstallation
note
The device is not tight if only one or none of the cable glands
is used
• The device is only tight when the cable glands are either wired or
sealed. To seal a cable gland, do the following:
→ Loosen the nut of the unused cable gland.
→ Remove the transparent disk.
→ Insert the supplied stopper gasket.
→ Screw the nut of the cable gland.
→ Loosen the nuts of the cable glands.
→ Insert each cable through a nut than through a cable gland.
123456
Power cable shield
Earth cable coming from the
housing
Second cable on a version with
a flow sensor holder in stainless
steel
Fig. 15: Earth connection terminal
+
-
18-36 VDC
1
2
2
Power cable shield
Power supply
Fig. 16: Earthing the device
→ Wire the 4-20 mA current output (see 8.3.1).
→ Wire the frequency output (see 8.3.2).
→ Wire the relay output (see 8.3.3).
→ Put the cover of the housing as described in Fig. 17.
→ Screw the 4 screws in an alternating pattern.
Fig. 17: Position of the cover of the device
English
Type 8041