Manual

28
Adjustment and commissioning
Warning
Danger due to non-conforming commissioning.
Non-conforming commissioning can lead to injuries and damage
the device and its surroundings.
• Before commissioning, make sure that the staff in charge have
read and fully understood the contents of these operating
instructions.
• In particular, observe the safety recommendations and intended
use.
• The device / the installation must only be commissioned by suit-
ably trained staff.
note
The device may be damaged by the environment
• Protect this device against electromagnetic interference,
ultraviolet rays and, when installed outdoors, the effects of the
climatic conditions.
When the device is energized and if the cover is open,
there is no protection against electric shocks.
9.2. Description of the electronic
board
The device has 2 operating modes: the Read mode and the Param-
eterizing mode. The functions of each mode are summarised in the
following table.
Operating mode Functions
Read To view:
• the fluid velocity measured by the device;
• the values set for the relay function.
Parameterizing • To calibrate the device.
• To set the relay parameters.
The 5 switches, the push-button, the green LED, the red LED
and the bargraph are used to set the parameters of the device
(see Fig. 26).
English
Type 8041