Manual

29
8175
ENGLISH
CALIBRATION MENU
4.4.1 Language
The selection of an alternative language is confirmed by the Enter-key and becomes imme-
diately active.
4.4.2 Engineering Units
ENTER
ENTER
0......9
The selection of the units will depend on the application and the configuration of the trans-
mitter via level, distance or volume for fluid measurement.
- If the transmitter is to be configured to measure Level or Distance, select the measuring
units and decimal points as required.
- If volume is to be selected and configured it is important to note that the transmitter
display within the ‘VOLUME TEACH-IN‘ may not be the measuring units selected.
The conversion of units by the transmitter only applies within the Volume Teach-In and
the table below displays the measuring units selected and the displayed units which will
be used within the Volume Teach-In.
UNIT
LANGUAGE
ENGLISH
DEUTSCH
FRANCAIS
ITALIANO
ESPANOL
Selected measuring units Units used for Teach-In
Distance Volume Distance Volume
cm L m L
mLmL
cm m
3
mm
3
mm
3
mm
3
cm US/Imp Gal Not to be used
m US/Imp Gal Not to be used
inch L Not to be used
foot L Not to be used
inch m
3
ft m
3
foot m
3
ft m
3
inch US/Imp Gal ft US/Imp Gal
foot US/Imp Gal ft US/Imp Gal