User guide

127
Maintenance and troubleshooting
"M0:W:Pulse x
1:1"
In "Pulse" mode, the volume entered for a
pulse is incorrect (see page 78).
→ Enter an appropriate volume
→ check the K factor.
9.3.5. "Maintenance" events related to calibration (Right orange
LED and icons
, and displayed)
When a "maintenance" event related to calibration is generated:
• The 4-20 mA output(s) operate normally
• The transistor outputs configured in "warning" mode switch.
Message dis-
played in the
"Information"
menu
Meaning Recommended action
"MxM:Time to cal."
A calibration is due on the sensor in the "Mx"
module.
The periodicity of calibrations is set in the
"INTERVAL" function in the "CALIB INTERVAL"
menu (see chap. 8.11.8 or 8.11.9)
→ Calibrate the sensor (chap. 8.11.8
or 8.11.9)
9.3.6. Error messages during data saving
The following error messages may be displayed when saving data (see chap. 8.10.5).
Message
displayed
Meaning Recommended action
"Missing memory
card"
No memory card has been inserted into the device
or the memory card has not been formatted.
→ Insert a memory card into the
device (see chap. 5.2.1).
→ Format the memory card.
"Datalogger is
enabled"
The memory card is already used by the
datalogger.
→ Deactivate the datalogger (see
chap. 8.10.18)
"File open" The file cannot be created.
→ Format the memory card.
"Memory card
write"
Write problem of the file.
→ Check that the memory card is not
write protected.
→ Check that there is enough free
space on the memory card.
9.3.7. Error messages during data loading
The following error messages may be displayed when loading data (see chap. 8.10.6).
Message
displayed
Meaning Recommended action
"Missing memory
card"
No memory card has been inserted into the device
or the memory card has not been formatted.
→ Insert a memory card into the
device (see chap. 5.2.1).
→ Format the memory card.
"Datalogger is
enabled"
The memory card is already used by the
datalogger.
→ Deactivate the datalogger (see
chap. 8.10.18)
Type 8619
english