Owner manual

73
LED - Color Assignments
Setting the Color Combinations16.1.
Setting of the possible color combinations with the help of the DIP switches:
S1 S2 S3 S4 Fault DIP1 DIP2 DIP3 DIP4
green yellow green red 0 0 0 0
yellow green yellow red 1 0 0 0
green red green yellow 0 1 0 0
red green red yellow 1 1 0 0
green yellow yellow red 0 0 1 0
yellow green green red 1 0 1 0
green red red yellow 0 1 1 0
red green green yellow 1 1 1 0
green yellow green green red 0 0 0 1
yellow green yellow yellow red 1 0 0 1
green red green green yellow 0 1 0 1
red green red red yellow 1 1 0 1
green yellow yellow yellow red 0 0 1 1
yellow green green green red 1 0 1 1
green red red red yellow 0 1 1 1
red green green green yellow 1 1 1 1
(S4IN may be a normally closed contact (NC) or a normally open contact (NO) - factory setting: NO contact,
it can be changed via the service interface.)
16.2. Blinking Pattern & Fault Signaling
The LEDs blink in different blinking patterns in the event of a fault or in various states.
Blinking patterns ON OFF Note
100 ms 100 ms
Blinks three times in the corresponding color for that
position:
Teach-In confirmation (after successful teaching:
the color for position 1 and 2 is continuously on)
Blinks three times in the corresponding fault color:
- if target could not be located in the measuring area
during teaching, or
- if teach position is too close (±0.5 mm) to a previously
defined teach position, or
- if magnetic manual control is used, even though manual
control function was disabled by software
english
Control Head Type 8681