Instruction Manual

 
ENGLISH ENGLISH
1 2
 
Always ensure the power supply is switched off before working on the
device. All the cable plugs must be plugged out. Use:
- a shielded cable with an operating temperature > +80 °C.
- a high quality voltage supply (filtered and regulated).

 
 

 

- Loosen threaded ring [1]
- Remove part [2] from the connector.
- Wire according to pin assignment (see 4.3.4,
4.3.5, 4.3.6 or 4.3.7)
4
3
1
5
2

- To open the plug, unfasten screw [1].
- Remove part [3] from part [2].
- Unscrew cable gland [5].
- Insert cable into part [2] via cable gland.
- Wire part [3] (see 4.3.2, 4.3.3, 4.3.6 or 4.3.7).
- Replace part [3] into part [2], by 90°-steps.
- Tighten cable gland [5]. Place gasket [4]
between the cable plug and the fixed connector of the controller
and plug the 2508 onto the fixed connector.
- Tighten screw [1] to ensure tightness and correct electrical
contact.