Instruction Manual

ENGLISH ENGLISH

 
 
Keep in mind that the process may be influenced by all the parameter
settings you make. Fill-in the table on page 24 with your settings of the
controller.
Frequency output cannot be programmed.

 
The device has three operating modes :

Display of the measured flow rate and the switching thresholds pro-
grammed. From the Normal mode, you can access the Calibration and
Simulation modes.

Access to the programming of all the parameters (unit, K-factor, calibra-
tion through the „Teach-in“ feature, output, filter, bargraph). From the
Calibration Mode, you can go back to the Normal Mode.

Entering a theoretical flow rate value to test the configuration program-
med in the Calibration Mode. From the Simulation Mode, you can go back
to the Normal Mode.