Install Manual

ManualsBrandsBurndy ManualsSolar & Wind PowerWEEBLUG-6.7

WEEB-BNDJMP6.7

4004188

Document Number 50015231 Rev D

Page 1 of 6

PLEASE READ

CAREFULLY

BEFORE

INSTALLING

Washer, Electrical Equipment Bond

WEEB

WASHER

INSTALLATION INSTRUCTIONS

For Unirac Solar Mount only

Please read carefully before installing.

Burndy LLC recommends that the sufficient details of the installation be

submitted to the AHJ for approval before any work is started.

WEEB-UMC

WEEB-LUG-6.7

NOTICE

WEEB-LUG-6.7HS

WEEB-DMC

Summary of content (6 pages)

PAGE 1
Washer, Electrical Equipment Bond WEEB WASHER INSTALLATION INSTRUCTIONS For Unirac Solar Mount only Please read carefully before installing. Burndy LLC recommends that the sufficient details of the installation be submitted to the AHJ for approval before any work is started. NOTICE PLEASE READ CAREFULLY BEFORE INSTALLING WEEB-UMC WEEB-LUG-6.7 WEEB-DMC WEEB-LUG-6.7HS WEEB-BNDJMP6.7 4004188 Document Number 50015231 Rev D © 2015 BURNDY LLC.
PAGE 2
WEEB-UMC COMPATIBILITY The WEEB washer family of products can be used to bond anodized aluminum, galvanized steel, steel and other electrically conductive metal structures. All installations shall be in accordance with NEC requirements in the USA and with CSA C22.1 in Canada. The WEEB washers are for use with modules that have a maximum fuse rating of 25A or less. Certain module frames do not have enough structural strength to withstand the force required to embed a WEEB washer.
PAGE 3
SYSTEM OVERVIEW Important notes: 1. Use general purpose anti-seize compound on fastener threads when installing WEEB washers (unless already pre-applied). 2. Bond to ground path is accomplished through WEEB washer, since midclamps and endclamps are not electrically bonded. 3. Secure PV cables and reliably route cables away from top down clamps using optional Wiley cable clips. Document Number 50015231 Rev D © 2015 BURNDY LLC.
PAGE 4
WEEB-UMC LAYOUT EVEN NUMBER OF MODULES IN ROW X X X X X DENOTES PLACES TO INSTALL WEEB-UMC COLUMN X ROW = C X R = 4 X 1 = 4 WEEB-UMC NEEDED = 4 ODD NUMBER OF MODULES IN ROW X X X X X X X DENOTES PLACES TO INSTALL WEEB-UMC [ COLUMN +1 ] X ROW = [ C + 1 ] X R = [ 5 + 1 ] X 1 = 6 WEEB-UMC NEEDED = 6 Note: When replacing a single faulty module, also remove the adjacent module which contacts the same WEEB washers as the faulty module.
PAGE 6
Customer Service Department 7 Aviation Park Drive Londonderry, NH 03053 1-800-346-4175 1-603-647-5299 (International) Document Number 50015231 Rev D © 2015 BURNDY LLC.