User Guide
3
A. General  This boiler is equipped with controls for 
proper operation. All controls must be in proper 
working order. Contact a qualied service agency 
to provide annual maintenance as specied in the 
Installation, Operating and Service Instructions.
WARNING
Service on this boiler should be undertaken only 
by trained and skilled personnel from a qualied 
service agency.
1. Limit A device which automatically interrupts 
boiler operation when the steam pressure exceeds 
the set point. See Figure 1. Maximum allowable 
pressure is 15 psi. Steam pressure can be read on the 
Pressure Gauge.
Basic Operation
Figure 1: Control Locations
CAUTION
Should overheating occur or the gas supply fail to shut off, do not turn off or disconnect the electrical 
supply to the pump. Instead, shut off the gas supply at a location external to the appliance.
En cas de surchauffe ou si I'admission de gaz ne peut être coupée, ne pas couper ni débrancher 
l'alimentation électrique de la pompe. Fermer plutôt le robinet d'admission de gaz à l'extérieur de I'appareil.
Do not use this boiler if any part has been under water. Immediately call a qualied service technician to 
inspect the boiler and to replace any part of the control system and any gas control which has been under 
water.
2.  Low Water Cutoff  A device which automatically 
interrupts boiler operation when the surface of the 
boiler water falls to the lowest permissible operating 
level. See Figure 1. The lowest permissible 
operating level is indicated on a plate adjacent to 
the gauge glass. The low water cutoff automatically 
resets when water returns to its normal level. Boiler 
operation resumes with a call for heat.
3.  Blocked Vent Switch  See Figure 7. A device 
which automatically interrupts boiler operation 
when excessive vent system blockage occurs. Do 
not attempt to place boiler in operation if control 
was activated to interrupt boiler operation. Contact 
a qualied service agency.
CAUTION
Do not reset Blocked Vent Switch unless a 
qualied service agency has determined and 
corrected the cause of any blockage in the vent 
system or chimney.










