User's Manual

Chapter 3 Conversion: Install Components, Cover, and Front Bezel

4. Rotate the control panel until it is aligned with the rack position of the

NetServer, as shown in Figure 3-3. Be careful of the ribbon cable that

connects the control panel to the NetServer. Be careful not to damage it.

Compaq rack slots (on left)

Control Panel

HP rack slots (on right)

Figure 3-3. Reorient Control Panel to NetServer Chassis

NOTE There are two possible positions for the reinstallation of the

control panel, depending upon the rack in which the NetServer

will reside. Refer to Figure 3-3.

5. Refer to Figure 3-3. Mount the control panel in the set of slots appropriate

for your rack:

◊

Slots for the HP rack are on the right.

◊

Slots for the Compaq rack are on the left.