User's Manual

Chapter 3 Conversion: Install Components, Cover, and Front Bezel
30
Left Rear
Rack Column
Rear of NetServer
Cable Management Arm
Figure 3-8. Attaching the Cable Management Arm
3. Install the two 6-32 Torx T-15 screws in the two threaded holes on the rear
of the NetServer.
4. Orient the cable management arm as shown in Figure 8-17.
5. Install the flange over the 6-32 screws and tighten them.
6. Attach the other flange of the cable arm to the rear column of the rack with
the two M-5 Torx T-25 screws, included with the arm.
7. Extend the HP NetServer out of the rack to ensure the Cable Management
Arm moves with the chassis without binding.
8. Slide the HP NetServer back into the rack.
9. At the front of the rack, insert the screws through the flanges into the rack
nuts and secure the HP NetServer to the front rack columns with a Torx
T-25 driver.
Each of the HP NetServer's two front flanges has two slots, which should
line up with the rack nuts previously mounted on the rack columns.