Cartridge Calibrated Custom Clicker (plus Wind Map) User Guide 331 E. 8th St. Greeley, CO 80631 970-356-1670 www.BurrisOptics.com Facebook.
The Burris C4 Plus (Cartridge Calibrated Custom Clicker – plus Wind Map) system gives shooters and hunters the ability to match elevation adjustment to their favorite cartridge and bullet, making pinpoint accuracy easier to achieve. Send us your cartridge information online and we’ll provide a custom elevation knob that matches your favorite load. PLUS, we’ll provide a customized Wind Map that shows, in MOA, a 10 MPH wind hold-off value for your cartridge at 100-yard increments.
How to Receive Your Free Custom Clicker and Wind Map 1. Determine precisely the load you will shoot - either a factory load or handload. 2. If choosing a factory load and if you have access to a chronograph, measure the actual velocity of the factory load. If you do not have access to a chronograph and/or do not provide a muzzle velocity to us, we will use the advertised velocity for your factory load. 3.
Installing Your Custom Clicker Elevation Knob 1. It is best to sight-in your riflescope prior to installing your Custom Clicker. 2. Being careful not to rotate the elevation knob, loosen the three set screws that hold the elevation knob in place. Lift the knob up and off of the scope. 3. Place the Custom Clicker onto your scope, aligning your sight-in yardage number to the reference mark on the scope. 4.
How to Use Your C4 Plus Riflescope Calculating Holdover/Hold-Off The C4 Plus Custom Clicker ensures that elevation adjustment perfectly matches the ammunition you are shooting, and when used properly eliminates the need to calculate holdover. Determining an accurate distance to your target is key, and Burris recommends using a rangefinder in the field for optimum accuracy. Once the distance to your target is confirmed, turn the dial on your Custom Clicker elevation knob to match that distance.
Installing the Wind Map Each Wind Map is shaped such that it can be easily installed and used in multiple positions such as the Objective Bell Taper, the Eyepiece, or the Riflestock. Our recommendation is to install the WindMap on the Objective Bell taper approximately 10° – 20° left or right of the top center depending on whether you shoot right- or left-handed. This position allows you to see the Wind Map with your “off-eye” while viewing through the scope.
Mounting the Scope C4 Plus riflescopes are available with either 1” or 30mm body tubes; please be sure you choose the correct ring sizes for your model as indicated by the end label sticker on your riflescope box . We recommend using high-quality rings and bases, like Burris Zee Rings or Signature Rings. Quality components ensure that your scope will remain safely and securely mounted, and will provide the maximum accuracy.
Warranty This C4 Plus line of riflescopes is covered by the Burris Forever Warranty™! Thank you for choosing Burris. You can be confident that the optic you purchased is built to the most exacting standards. You can count on Burris to perform every time you use it. We’re so confident in the craftsmanship of our products that we back them with a no questions asked Forever Warranty. We will repair or replace your Burris optic if damaged or defective: • No charge to you. • No questions asked.
