Operating instructions

Operating guidelines

Volume

Speech

Rington

The volume level for the voice feedback and the selected ring tone can

be set in an additional sub menu.

Available as voice commands are „LOUDER“, „LESS“, „MAXIMUM“,

„MINIMUM“ and „ACCEPT“.

For some radios it may cause problems if the HFCK starts with voice

response immediately after the mute signal. Some radios need some

time for a corresponding activation and reaction to the mute signal.

This will be indicated to you through the fact that you don’t hear the

signal tone at the start of the voice control. To avoid this effect, you can

enter a maximum delay of up to three seconds in the „MUTE DELAY“

menu item. It is only after this time has elapsed that the HFCK begins

with the voice feedback.

Certain mobile telephones offer the possibility of being able to install

and operate a navigation solution. On many mobile phones, the sug-

gested directions are only transferred via the

Bluetooth

A2DP profile. If

you have not connected a suitable cable to the LINE-OUT output of the

HFCK and to the radio however, you are not able to hear these instruc-

tions.

With the External Audio menu item, it is possible to place these in-

structions on the PHONE-OUT output of the HFCK. This means that the

direction instructions are read out in monotone and the radio is also

muted. The HFCK takes priority with its functions, however, which me-

ans that if the voice control is active or in the event of an incoming call,

any direction instructions that are being issued at that time will be

muted.

Please note:

If the function is activated it is not possible to listen to X

music via A2DP via the LINE-OUT output.

Mute delay

External audio on