User's Manual

140 NAVI
Safety notice for off-road navigation
When you activate off-road navigation you are
shown a notice that off-road navigation serves
only to assist the driver.
û Select "
Activate „off-road“" to close this safety
notice.
Landmark navigation
Within the framework of landmark navigation you
can
– enter a destination by entering an address
(> page 124),
– enter a destination by specifying the
geographical coordinates (> page 138),
– enter a destination in the map display
(> page 137),
– insert a destination from the list of previous
destinations
(> page 126),
– insert a destination from the personal
destination memory (> page 128), and
– enter a maximum of four stopovers, in this
case called "Landmarks" (> page 136).
Destinations in the digitized area can also be
selected from lists and navigated to when off-road
navigation is active.
These destinations are then reinterpreted as off-
road destinations and navigated to using landmark
navigation.
 In the off-road navigation only single
destinations are stored in the list of previous
destinations.
Lists of landmarks are stored in the personal
destination memory.
Route guidance in landmark navigation
Route guidance is by means of a compass display
with the vehicle symbol in the center of the
compass rose.
The orange-colored direction arrow always points
in the direction of the landmark currently being
navigated to.
The various landmarks are shown as colored
flags.
The angular deviation between the current
direction of travel and the direction to the next
landmark is shown as an orange-colored segment
and displayed in degrees.