Operator`s manual

Figure 15 One Bag Removed

Figure 16

Hood

Draw Latches

Bags With Bag Rings Installed

Upper Frame Assembly

Inlet

the bag onto the bag ring openings and slide the bag

around the ring until the slot bracket in the bag ring is

protruding through the opening in the bag. Do this for

each of the three bags. (Figure 14)

Install the completed assemblies onto the support

frame and close the hood. Fasten both draw latches to

hold the hood closed. (Figures 15 & 16)

NOTE: After bags have been installed, the engine

exhaust outlet may need to re-directed downward to

prevent over heating the bags.

To empty the bag, remove the bag ring by lifting and

sliding rearward. Grasp the loop on the bottom of the

bag, turn it upside down and empty the collected

debris. Repeat for the other bags. Reinstall all bags,

close the hood and reattach the draw latches.

Plastic lawn and leaf bags, 55 gallon size, may be

used inside the cloth bags. Be sure to leave enough

plastic bag hanging over the frame so the plastic bag

can be twist tied before emptying.

Engine Exhaust Outlet Pipe

Lower Frame Assembly