Instruction Manual

Installing your Built-in Oven
15
1
2
3
4
5
N
L
Connection of
diagram 1
diagram 2
diagram 3
Installing your Built-in Oven
Bringing it all together
Provision for Ventilation
The appliance housing used must provide adequate ventilation.
For built-in installation, a minimum ventilation space of
85 – 90mm x 40mm must exist between the rear of the appliance and the back of the housing
or an adjacent wall.
If a tall housing is to be installed flush with the ceiling, a 20cm² ventilation cut-out must be
provided at the top of the housing.
tt n n o r pp a
(refer to diagram 2):
To install the cable, proceed as follows (refer to diagram 3):
Remove the wire clamp screw and the three contact screws L(4)
N(5)
Fasten the wires beneath the screw heads using the following color scheme :Blue (N) Brown (L) Yellow-
supply cable in place with the clamp and close the cover of the terminal board.
Electrical connections must be carried out by a suitable qualified person and in accordance with
all
relevant local building and installation regulations.
Installing your Built-in Oven
15
or online at www.bush-support.com If you still require further assistance, call one of our experts on 01759 487838.
1
2
3
4
5
N
L
Connection of
(refer to diagram 4)
diagram 1
diagram 2
diagram 3
diagram 4
.
.
Installing your Built-in Oven
Bringing it all together
Provision for Ventilation
The appliance housing used must provide adequate ventilation.
For built-in installation, a minimum ventilation space of
85 – 90mm x 40mm must exist between the rear of the appliance and the back of the housing
or an adjacent wall.
If a tall housing is to be installed flush with the ceiling, a 20cm² ventilation cut-out must be
provided at the top of the housing.
tt n n o r pp a
(refer to diagram 2):
To install the cable, proceed as follows (refer to diagram 3):
Remove the wire clamp screw and the three contact screws L(4)
N(5)
Fasten the wires beneath the screw heads using the following color scheme :Blue (N) Brown (L) Yellow-
Green
Fasten the
supply cable in place with the clamp and close the cover of the terminal board.
Warning:
Warning:
Connections must be in accordance with the relevant local building and installation regulations.
Connect the power cord must be in accordance with the instructions listed in the table below.
1
2
3
4
5
N
L
Connection of
(refer to diagram 4)
diagram 1
diagram 2
diagram 3
diagram 4
Installing your Built-in Oven
Bringing it all together
Provision for Ventilation
The appliance housing used must provide adequate ventilation.
For built-in installation, a minimum ventilation space of
85 – 90mm x 40mm must exist between the rear of the appliance and the back of the housing
or an adjacent wall.
If a tall housing is to be installed flush with the ceiling, a 20cm² ventilation cut-out must be
provided at the top of the housing.
tt n n o r pp a
(refer to diagram 2):
To install the cable, proceed as follows (refer to diagram 3):
Remove the wire clamp screw and the three contact screws L(4)
N(5)
Fasten the wires beneath the screw heads using the following color scheme :Blue (N) Brown (L) Yellow-
Green-Fasten the supply cable in place with the clamp and close the cover of the terminal board.
Important:
Wire cross-sectional area(mm2)
Connection mode
L N E
1N~ Min2.5 Min2.5 Min2.5
If
you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,