Instruction Manual

Installing your Cooker
Bringing it all together
Installing your Cooker
18
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
• Green/Yellow (Earth) wire to the terminal marked
"PE".
• Brown (Live) wire to the terminal marked "L".
• Blue (Neutral) wire to the terminal marked "N".
• For this connection, a ‘Twin and Earth 6242Y’ type
cable should be used.
Anti-tilting kit
Anti-tilting Bracket
(x1) (will be attached
to the wall)
Dowel
(x1)
Screw
(x1)
1 2
3
The document bag contains an anti-tilting kit. Loosely
attach the anti-tilting bracket (1) to the wall using the
screw (2) and dowel (3), following the measurements
shown in the figure and table below. Adjust the height
of the anti-tilting bracket so that it lines up with the
slot on the cooker and tighten the screw. Push the
appliance towards the wall making sure that the anti-
tilting bracket is inserted into the slot on the rear of the
appliance.
A
B
Anti-
tilting
bracket
Wall
Product Dimensions
(Width X Depth X Height) (Cm)
A (mm) B (mm)
60x60x90 (Double Oven) 297.5 52
50x60x90 (Double Oven) 247.5 52
90x60x85 430 107
60x60x90 309.5 112
60x60x85 309.5 64
50x60x90 247.5 112
50x60x85 247.5 64
50x50x90 247.5 112
50x50x85 247.5 64
Adjusting the feet
Your product stands on four adjustable feet. For safe
operation, it is important that your appliance is correctly
balanced. Make sure the appliance is level prior to
cooking. To increase the height of the appliance, turn
the feet anti-clockwise. To decrease the height of the
appliance, turn the feet clockwise.
It is possible to raise the height of the appliance up to
30 mm by adjusting the feet. The appliance is heavy
and we recommend that a minimum of 2 people lift it.
Never drag the appliance.