Instruction Manual

Installing your Freestanding Cooker
Bringing it all together
Installing your Freestanding Cooker
18
If you require any technical guidance or f nd that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
Electrical connection
IMPORTANT: Electrical connections must be carried
out by a suitably qualified person and in accordance
with all relevant local building and installation
regulations.
The electrical cable should not be routed through
any area that may be aected by heat from the
ov
en, especially the area directly behind the oven.
Fitting on a Power Supply Cable
Connecting appropriate power supply terminal board/ connector block:

Using a screwdriver ,prize open tabs of the Terminal board cover.

Remove the wire clamp screw.

Fasten the wires beneath the corresponding screw heads, using brass ‘bridge’ for single phase supply.

Fasten cable clamp and close the cover of the terminal board.

The ac power supply should be 220-240 V, 50/60 Hz. For electric cookers, the minimum 45A fuse, or at least
45A a distribution circuit breaker. For gas cookers, the minimum 20A fuse, or at least 20A circuit breaker.