User manual

Using your CD Micro with DAB and Bluetooth

Let’s get started

Using your CD Micro with DAB and Bluetooth

If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the

Troubleshooting

Using the DAB Radio

Wire radio aerial

Please make sure that the wire aerial on the back of the Micro is fully extended and

adjusted before you attempt to tune to a DAB radio station (a vertical position is

recommended). This will ensure that the maximum signal strength is available when the

Micro begins to scan. Extending the aerial also ensures the best possible sound quality.

DAB radio mode

Check that your Micro is in DAB radio mode. If you are not already in DAB mode, briefly

press and release the ‘Mode’ button on the front of the Micro or on the remote control,

until you are in DAB mode (check the display).

The first time you use the Radio or if the station list is empty, your Micro will automatically

begin to scan for DAB radio stations. A progress bar will show the progress of the scan

and the number of stations found during the scan will also be displayed.

When the scan is complete your Micro will select the first available station and begin to

play. Stations are listed in numerical and then alphabetical order by default.

Changing DAB stations

In DAB mode:

1. Press and release the ‘Tune+’ or ‘Tune-’ on the front of the Micro or the and

buttons on the remote control to move through the available stations.

2. When the station that you would like to listen to is displayed press the rotary control

on the Micro to ‘Select’ or press ‘Select’ on the remote control. There will be a short

delay whilst your Micro tunes to your selected station.

Scanning for DAB stations

With DAB radio, additional stations and services regularly become available so it’s a good

idea to carry out a manual scan every now and then to make sure that you have the most

up to date station listing stored within the memory of your Micro.