User manual

Using your CD Micro with DAB and Bluetooth
Let’s get started
Using your CD Micro with DAB and Bluetooth
25
section of these instructions, or online at www.argos-support.co.uk If you still require further assistance, call one of our experts on 0345 600 3021.
Using the FM Radio
Wire radio aerial
Please make sure that the wire aerial on the back of the Micro is fully extended and
adjusted before you attempt to tune to an FM radio station (a vertical position is
recommended). This will ensure that the maximum signal strength is available when the
Micro begins to scan. Extending the aerial also ensures the best possible sound quality.
FM Radio mode
Check that your Micro is in FM radio mode. If you are not already in FM mode, briefly
press and release the ‘Mode’ button on the front of the Micro or on the remote control,
until you are in FM mode (check the display). When your Micro is in FM mode it can
receive Radio Data System or ‘RDS’ information if this is being transmitted by the
broadcaster. RDS information will often include the station name, detail about the
programme and the current time.
If you were listening to an FM station when you switched the Micro off then this station
will be automatically selected when you switch the Micro back on.
Tuning to an FM station
In FM mode:
1. Press and release the button on the Micro or the ‘Scan’ button on the remote
control to scan up the frequency band. Press and hold the button on the Micro
or the ‘Scan’ button on the remote control to scan down the frequency band.
Your Micro will search for the next available station and then stop on that station.
2. Press and release the ‘Tune+’ or ‘Tune-’ on the front of the Micro or the and
buttons on the remote control to fine tune each frequency in 0.05MHz steps, if
necessary.
Note: If reception is still poor check that the wire aerial is fully extended or try moving
the Micro to another location.