Instruction Manual

If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the

Troubleshooting

Using your Bluetooth speaker

Let’s get started

Power on

Slide the Power switch under the rubber cover on the back of the product to on. Your

Bluetooth speaker will switch on in Bluetooth mode. A tone will sound and the blue LED

on the top of the product will flash quickly whilst your product searches for Bluetooth

devices.

Standby mode

If the Bluetooth speaker does not receive an audio signal for approximately 15 minutes

it will go to Standby mode and the blue Bluetooth LED will flash slowly. Press and hold

the Play/Pause button to turn the product back on again. Alternatively you can slide the

power switch on the back of the product to off and then on again.

Power o

Slide the Power switch under the rubber cover on the back of the product to off.

Note: You will not be able to power off your Bluetooth speaker when you are charging

the battery. The red charging LED will remain on until the battery is fully charged.

Connect to a Bluetooth device

1. The blue LED on the top of the product will flash quickly whilst your product searches

for Bluetooth devices.

2. On the device that you would like to connect to your Bluetooth speaker via Bluetooth

(e.g. iPhone/iPad/Android/other phone/Tablet/Computer), turn on Bluetooth

connectivity and ensure that it is ‘discoverable’.

Note: If necessary, refer to the instructions for your device to add or set up Bluetooth.

3. Select to ‘Add new device’, if necessary.

Note: Some products will automatically search for a new device and so the ‘Add new

device’ option is not available.