Instruction manual PT-951
You’ll soon be enjoying your new Party Speaker. It all begins here, with your instructions. Don’t worry, there’s nothing too technical coming up. Just simple, step-by-step guidance to get you up and running quickly. Sound good? Then let’s get started. Help and Guidance We’re here to help you get the most from your Party Speaker. Should you require any guidance, a simple solution can often be found online at: www.bush-support.
Contents 1 2 3 Safety information General safety information 8 Power source 8 Moisture and water 9 Ventilation 9 Heat sources and flames 9 Getting to know your Party Speaker Positioning the Party Speaker 15 Power connection 15 Changing the mode 16 USB MP3 socket 16 USB 5V/1A Charge socket 16 Microphone sockets 17 Adjusting the volume 17 Equaliser (EQ) function 17 Mega Bass 17 Tone 17 Mute 18 Front face lights 18 Main speaker lights 18 Using your Party Speaker Power on
Contents 4 Listening to Music/Audio using Bluetooth 23 Aux in mode 24 Controls available on your Party speaker and Remote control: 25 Other information Technical specification 5 28 Product support Troubleshooting 32 Help and assistance 33 Disposal 34 If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting 4
This page is left intentionally blank section of these instructions, or online at www.bush-support.com If you still require further assistance, call one of our experts on 0345 600 3021.
This page is left intentionally blank
Safety information 1
Safety information Important - Please read these instructions fully before installing or operating General safety information • Keep the product and all its parts out of reach of small children. • This product is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.
Safety information Important - Please read these instructions fully before installing or operating Disconnect your Party Speaker from the mains power supply during thunderstorms. Always check that you have completely switched off your Party Speaker, before you change or disconnect the power supply. Where the mains power plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable.
This page is left intentionally blank
Getting to know your Party Speaker 2
Getting to know your Party Speaker You’ll be up and running in no time Ready? Let’s begin... Please read these instructions carefully. They contain important information which will help you get the best from your product and ensure safe and correct installation and operation. If you require any further assistance, our technical experts are happy to help. For full details, refer to the product support section at the end of these instructions. 1. Power on/off switch 2. Power socket 3.
Getting to know your Party Speaker You’ll be up and running in no time 4 5 6 7 14 15 16 17 8 9 10 11 18 19 20 21 12 13 22 23 24 25 Fig 2. 4. Top light panels 15. Microphone volume control 5. Aux in socket 16. USB 5V/1A charge socket 6. Mic 2 socket 17. USB MP3 socket 7. Mic 1 socket 18. Mute 8. Repeat (USB mode only) 19. Mic first 9. Skip back (Bluetooth/USB mode) 20. Front facing light control 10. Play/Pause (Bluetooth/USB mode) 21. Speaker light control 11.
Getting to know your Party Speaker You’ll be up and running in no time 3 4 5 FACE LIGHT MUTE SPK LIGHT BASS M.FIRST TREBLE 6 7 8 2 1 FACE LIGHT MUTE SPK LIGHT BASS M.FIRST TREBLE 9 VOL- VOL+ EQ M.BASS 16 17 1 18 10 2 3 4 5 6 7 8 9 10 11 19 REPEAT UNPAIR 20 12 15 13 Fig 3. 14 1. Power on/off 11. Skip forward 2. Mode 12. Previous track/preset 3. Front facing light control 13. Play/Pause 4. Mute 14. Skip back 5. Speaker light control 15.
Getting to know your Party Speaker You’ll be up and running in no time Positioning the Party Speaker It is important that you consider carefully in advance where your Party Speaker will be situated and make sure that it is: • on a flat and stable surface. • in a well ventilated, cool, dry, clean place - away from direct sunlight, heat sources, vibration, dust, moisture and/or cold.
Getting to know your Party Speaker You’ll be up and running in no time Changing the mode Your party speaker has 3 modes, Bluetooth, Aux in and USB play. 1. Short press the Power/Mode button to change between Bluetooth, and Aux in modes. To use USB Play mode, just plug a USB stick into the USB MP3 socket. USB MP3 socket With your Party speaker you can play MP3, WAV and WMA music files directly from a USB stick.
Getting to know your Party Speaker You’ll be up and running in no time Microphone sockets Your Party speaker has two microphone sockets . When you connect a microphone, the MIC FIRST feature becomes active and the music sound is lowered so that the microphone can be heard. You can short press the MIC FIRST button to turn this feature on or off. You can adjust the volume and effect of the microphone by using the MIC VOL and MIC ECHO rotary controls on the top of the Party speaker.
Getting to know your Party Speaker You’ll be up and running in no time 3. Short press the TONE button again to switch between the Bass (b), Treble (t) and Volume settings. Mute 1. Short press the MUTE button on the Party speaker or on the Remote control to turn the volume off.. U-00 will be displayed and then the product will revert to the current Mode display, e.g. -bt-. 2. Short press the MUTE button to turn the volume on again.
This page is left intentionally blank section of these instructions, or online at www.bush-support.com If you still require further assistance, call one of our experts on 0345 600 3021.
This page is left intentionally blank
Using your Party Speaker 3
Using your Party Speaker Let’s get started Power on After you have connected the power to the Party speaker, press the power switch on the back of the Party speaker at the top to On. The product will switch on, ‘Hi’ will be displayed followed by ‘-bt-’, a bluetooth icon will flash to indicate that you Party speaker is searching for Bluetooth devices. Standby mode If the Party Speaker does not receive an audio signal for approximately 20 minutes, it will go to Standby mode.
Using your Party Speaker Let’s get started Note: Some products will automatically search for a new device and so the ‘Add new device’ option is not available. 4. When found, your Party speaker will be displayed as ‘BUSH P-951’. Select the device name to begin pairing. 5. When pairing is complete ‘Connected’ will be announced and the bluetooth icon will stop flashing and will remain continuously on. 6.
Using your Party Speaker Let’s get started Aux in mode If you are not already in Aux in mode, short press the mode. Check the display. Power/M button to go to Aux in 1. Connect one end of a 3.5mm audio cable (not supplied) to the headphone (or auxiliary out) socket of your secondary device. Connect the other end to the AUX IN socket on the top of your Party Speaker. 2. Press the Play button on your external device to start playback through the Party Speaker. 3.
Using your Party Speaker Let’s get started Controls available on your Party speaker and Remote control: Short press to Play/Pause Short press to skip forward Short press to skip back REPEAT Note: The USB stick. Short press to repeat the current track or repeat all. REPEAT function is only available when you are playing music from a Note: Remember to remove the USB stick from the USB MP3 socket after use. section of these instructions, or online at www.bush-support.
This page is left intentionally blank
Other information 4
Other information Helpful technical information Technical specification Audio output: 2 x 30W RMS at 10% THD RF output power: 0dB Power supply: Input: 100-240V 50/60Hz Power consumption: 70W Auto standby time: 20 minutes Auto standby power consumption: 0.5W Aux in socket: 3.5mm USB charge socket: 5V/1A Bluetooth: Version 4.2 Pairing name: BUSH P-951 Profiles: A2DP, AVRCP Frequency range: 2.4GHz-2.480GHz This product is intended for use within the UK.
Other information Helpful technical information Declaration of Conformance Hereby, Argos Ltd, declares that this Party Speaker P-951 is in compliance with the essential requirements and other relevant provisions of the Radio Equipment Directive 2014/53/EU. The complete declaration of conformity can be obtained by contacting https://www.argos-support.co.uk/ The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc.
This page is left intentionally blank
Product support 5
Product support Help is always at hand Troubleshooting Unable to pair with a Bluetooth device: • Check that you are in Bluetooth mode. • Ensure that you are within range of the Party Speaker for Bluetooth functionality, 10 metres or less (33 feet or less). • Check that the device you are attempting to pair with supports A2DP stereo audio transmission. • Move the Party Speaker and Bluetooth device away from other Bluetooth devices/ electrical equipment.
Product support Help is always at hand Help and assistance If you require any technical guidance or find that your Party Speaker is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions or online at www.bush-support.com If you still require further assistance, call one of our experts on 0345 600 3021*. To help give us give you a fast and efficient service please have the following information ready: Model Ref.
Product support Help is always at hand Disposal • Disposal of your old product. Your product is designed and manufactured with high quality materials and components, which can be recycled and reused • When this crossed out wheeled bin symbol is attached to a product it means the product is covered by the European Directive 2012/19/EC. • Please make yourself aware of the local collection system for electrical and electronic products.
Product support Help is always at hand Call us now and register your 12 month guarantee Thank you for choosing Bush. Your new product is guaranteed against faults and breakdowns for 12 months. Don’t forget to register it with us today so we can provide you with our best possible after-sales service and useful updates. www.bushregistration.co.uk FREEPHONE* 0800 597 8548 Lines are open 8am - 8pm, 365 days a year. *Calls may be recorded and monitored.
Contact: www.bush-support.
