Instruction manual Built-in Solid Plate Hob RL60SPH
You’ll soon be enjoying your new Built-in Hob It all begins here, with your instructions. Don’t worry, there’s nothing too technical coming up. Just simple, step-by-step guidance to get you up and running quickly. Sound good? Then let’s get started. Help and Guidance We’re here to help you get the most from your Built-in Hob. Should you require any guidance, a simple solution can often be found online at: www.bush-support.com If you still require further assistance, call one of our experts on 01759 487838.
Contents 5 1 Care and Maintenance 6 2 3 24 25 Getting to know your Hob Overview 11 Accessories 12 6 Product support Troubleshooting 28 Help and assistance 29 Declaration of conformance to Installing your Hob product standards 30 14 Disposal 30 15 Guarantee 31 16 4 Using your Hob 20 20 21 or online at www.bush-support.
Safety information 1
Safety information Important - Please read these instructions fully before installing or operating INSTALLATION WARNINGS DURING USAGE IMPORTANT: Prior to Installation ensure that the local supply conditions (electricity voltage and frequency) are compatible with the requirements of your built-in hob.
Safety information Important - Please read these instructions fully before installing or operating IMPORTANT: Make sure the built-in hob control knobs are all in the off position when not in use. IMPORTANT: If you do not intend to use your hob for a long period of time turn off the electric supply to the cooker. GENERAL SAFETY WARNINGS IMPORTANT: This appliance has been designed for non-professional, domestic use only. Do not use this cooker for commercial use or any other application e.g. room heating.
Getting to know your Built-in Hob 2
Getting to know your Built-in Hob You’ll be up and running in no time Ready? Let’s begin... Please read these instructions carefully. They contain important information which will help you get the best from your Built-in Hob and ensure safe and correct installation and operation. If you require any further assistance, our technical experts are happy to help. For full details, refer to the product support section at the end of these instructions.
Getting to know your Built-in Hob You’ll be up and running in no time 2 1 1 2 3 4 1 =Rapid heating plate 2000W 2 =Rapid heating plate 1500W 3 =Heating plate control knobs 4 =signal lamp or online at www.bush-support.
Getting to know your Built-in Hob You’ll be up and running in no time "DDFTTPSJFT 1. Bracket*4 2. Screw*4 3.
Installing your Built-in Hob 3
RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
Installing your Built-in Hob Bringing it all together Fixing the seal to the back of the Hob The hob must be sealed to the work surface to prevent liquid from entering into the cabinet. A tape seal is supplied with the hob. Refer to Fig. 1 1. Turn the hob over and place on a secure, level surface. 2. Spread the seal around the left, front, right and rear outer edges of the cooktop. Take special care in the corners making sure there are no gaps.
Installing your Built-in Hob Bringing it all together Fig. 1 Mains Connector Rear Screw (R) Seal no gaps in corners Rear side Rear Screw (R) (R) ) e (F t sid Fron Front Screw (F) Front Screw (F) Fig.
Installing your Built-in Hob Bringing it all together Electrical connection Appliances with three-pole cable are set up for operation with alternating current at the voltage and frequency indicated on the rating plate. The earth conductor is yellow/green. The connection to the electricity supply must be made by a qualified person and following the regulations in force.
Using your Built-in Hob 4
Using your Built-in Hob Getting the most from your appliance Operation of the top with the electric plates The electric tops can either be of the standard type, or of the rapid type. These last feature a red mark at their centre. According to your needs, the tops can be adjusted by turning the knobs either clockwise or anti-clockwise on 6 position besides the 0 position (off). The positions marked by the higher numerical index match the maximum output of heat (see table).
Using your Built-in Hob Getting the most from your appliance Utensils Use pans with flat bottoms. Uneven or thin bottoms will waste energy and are slow to cook Use pans slightly larger than the hotplates. Smaller pans will waste energy. Do not use oversized pans. More than 50mm overhang can overheat the hob components and can cause fine cracks in the enamel hob which will trap dirt. Use only dry utensils. Do not place wet or steamy parts (eg. lids) on the hotplates.
Care and maintenance 5
Care and maintenance Looking after your appliance Cleaning WARNING! Isolate the power supply to the built-in Hob and make sure that the built-in hob is cool. Before cleaning your hob or performing maintenance, make sure that the cooking zone control knobs are set to ‘OFF’. To extend the life of your hob, it must be cleaned frequently. Stainless Steel: Stainless steel parts must be cleaned frequently with mildly warm soapy water and a soft sponge and then dried with a soft cloth.
Care and maintenance Looking after your appliance Technical specification We apologise for any inconvenience caused by minor inconstancies within these instructions that may occur due to product improvements and development All images and drawings are for illustration purposes only. or online at www.bush-support.
Product support 6
Product support Help is always at hand Troubleshooting 1. If no electrical functions appear to work, check the isolation switch has not been turned off also check the fuse in the switch and the circuit breaker in you consumer unit 3. D O NOT ATTEMPT TO REPAIR THIS APPLIANCE YOURSELF. CALL BUSH PRODUCT SUPPORT ON 01759 487838 OR CONSULT A QUALIFIED ELECTRICIAN 2.
Product support Help is always at hand Help and assistance If you require any technical guidance or find that your Built-in Hob is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions or online at www.bush-support.com If you still require further assistance, call one of our experts on 01759 487838*.
Product support Help is always at hand Declaration of conformance to product standards This appliance conforms to all relavant standards applicable to domestic appliances sold in the UK Disposal This appliance/fitting is marked according to the European directive 2012/19/EU on Waste Electrical and Electronic Equipment (WEEE).
Call us now and activate your 12 month guarantee Thank you for choosing Bush. Your new product is guaranteed against faults and breakdowns for 12 months. Don’t forget to register it with us today so we can provide you with our best possible after-sales service and useful updates. www.bushregistration.co.uk FREEPHONE* 0800 597 8548 Lines are open 8am - 8pm, 365 days a year. *Calls may be recorded and monitored.
Contact: www.bush-support.