Instruction Manual

Care and maintenance
Looking after your appliance
Care and maintenance
28
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
or online at www.bush-support.com If you still require further assistance, call one of our experts on 0345 257 7271.
CLEANING AND CARE
IMPORTANT: Do not use industrial chemicals to clean
your dryer. Do not use a dryer that has been cleaned with
industrial chemicals.
CLEANING THE LINT FILTER
IMPORTANT: DO NOT FORGET TO CLEAN THE LINT
FILTER AFTER EACH USE.
To clean the lint filter:
1. Open the loading door.
2. Pull up the lint filter to remove it.
3. Use your hands or a soft cloth to clean the lint.
4. Close and refit the lint filter.
After the dryer has been used for a certain period, you may
find a build-up on the filter which may cause an obstruction.
Should this arise, remove and clean the filter with warm
water and then dry thoroughly before reinstalling
1
2
3
4
EMPTYING THE WATER TANK
1. Pull the drawer cover and carefully take out the tank.
2. Empty the water in the tank.
3. If there is lint accumulated on the discharge cap in
the tank, clean it with water.
4. Refit the water tank.
IMPORTANT: Never remove the water tank when the
programme is running. The water condensed in the water
tank is not suitable for human consumption.
IMPORTANT: DO NOT FORGET TO EMPTY THE WATER
TANK AFTER EACH USE.
Cleaning the Condenser
IMPORTANT: Clean the condenser when you see the
warning “Condenser Cleaning”.
IMPORTANT: EVEN IF THE “CONDENSER CLEANING
WARNING LED” IS NOT ON: CLEAN THE CONDENSER AFTER
EVERY 30 DRYING PROCESSES OR ONCE A MONTH.
If the drying process is completed, open the loading door
and wait for it to cool down.
1
2