Instruction Manual

Care and maintenance
Looking after your appliance
Care and maintenance
29
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
or online at www.bush-support.com If you still require further assistance, call one of our experts on 0345 257 7271.
1. Open the plinth and release the 2 cover locks of the
condenser.
2. Hold the condenser by the plastic part and pull it out.
3. Clean it with a showerhead and wait for the water to
drain off.
4. Fully insert the condenser into its seat and lock the 2
locks.
5. Close the plinth cover
CLEANING THE HUMIDITY SENSOR
Inside the machine, there are humidity sensors that detect
whether the laundry is dry or not.
To clean the sensors:
1. Open the loading door of the machine.
2. If the machine is still hot due to the drying process,
wait for it to cool down.
3. Using a soft cloth soaked in vinegar, wipe the metal
surfaces of the sensor and dry them.
IMPORTANT: CLEAN THE METAL SURFACES OF THE
SENSOR 4 TIMES A YEAR.
IMPORTANT: Do not use metal tools to clean the metal
surfaces of the sensor.
WARNING: Due to the risk or fire and explosion, do not
use solution agents, cleaning agents or similar products
when cleaning the sensors.
1
2
CLEANING THE INNER SURFACE OF THE LOADING DOOR
IMPORTANT: DO NOT FORGET TO CLEAN THE INNER
SURFACE OF THE LOADING DOOR AFTER EACH DRYING
PROCESS.
Open the loading door of the dryer and clean all of the
inner surfaces and the gasket with a soft, damp cloth.