Manual

REVERSING THE DOOR (OPTION) - Models XCD-185 and XCD-280

How to reverse the door

 Remove the right three hinges by loosening and removing the screws with screwdriver.

 Carefully lower the doors and take them off the cabinet.

 Change the hinges to the left sides.

 Mount the top and bottom hinges first, then insert the two doors.

 Mount the middle hinges.

Note: As the door gasket gets pressed-in during shipment, after reversing the door the gasket might have to

be reset. This will be good for seal to avoid any air escaping. If there is a gap between the cabinet and the

door gasket, set the gasket by gently pulling it out to seal the gap. If necessary, you are recommended also to

use the hair drier to warm the gasket to get rid of the gap.

Inside Lighting (Not available in every model)

The LED lamp works with four batteries,1.5volts each,AAA size.

Batteries are mounted on the back of the refrigerator. You need to replace the batteries periodically in

case that the lamp is not bright enough.