User's Manual

7:00 PM. No Field Scan recording would occur from 8AM to 5:30PM,

or from 7PM to 6AM. Remember, Field Scan recording is independent

of normal triggers due to animal activity–even if no animals enter the IR

sensor coverage zone, an image or video will still be captured every 15

minutes during the block(s) of time. If an animal triggers the camera “in

between” the 15 minute intervals, it will be recorded, same as it would

if you had setup the camera with Field Scan turned Off. Note: Field

Scan settings of frequent intervals and/or long periods between

start and stop time can reduce battery life.

(Step 1)-set Field

Scan Mode to “On”

(Step 2)-select Field

Scan "A" (press OK)

(Step 3)-set Field

Scan "A" Stop & Start

(Step 4) (opt)-select Field

Scan "B" (press OK)

(Step 5) (opt)-set Field

Scan "B" Stop & Start

Steps 4 & 5 are

optional (only

required if you want

to set up a second

block of Field Scan

recording with

different stop and

start times)

(Step 6)-select Field

Scan "Interval"

(Step 7)-set Field

Scan Interval

Note: the Interval

Setting sets the

timing between each

image for both Field

Scan "A" and "B"

recording blocks.