Instructions

15
of 2 minutes continuous video before a new
video is initiated.
With Interval set to 2 sec or longer, and LED
Control=High, for night videos: same as
daytime, but maximum length is 15 seconds
before recording ends and a new video is started
if a new trigger occurs.
With Interval set to 2 sec or longer, and LED
Control=Med/Low, for night videos: same as
daytime, but maximum length is 60 seconds
before recording ends and a new video is started
if a new trigger occurs.
Interval
10S (second) default, with
as60M (minute) to .2S (half
second) range of settings
available. (60M-1M are set in
one minute increments, 59S-
3S are set in one second
increments, followed by the
.6S setting)
Selects the length of time that the camera will
“wait” until it responds to any additional triggers
from the PIR after an animal is first detected and
remains within the sensor’s range. During this
user set “ignore triggers” interval, the camera
will not capture photos/ videos. This prevents
the card from filling up with too many
redundant images. Settings begin with 10
second default when parameter is first selected.
Setting the Interval time to .6 second will
capture the maximum # of images, but some
may appear "washed out" if animal is too close
to camera at night. Note: after setting down
past “.6S”, settings start over at “60M”.
Format
Execute (followed by an
additional No/Yes step)
Deletes (erases) all files stored on a card to
prepare it for reuse. Always format a card that
has been previously used in other devices.
Caution! Make sure you have downloaded and
backed up any files you want to preserve first!
Press OK to execute, press MENU (or select NO
then press OK) to exit without formatting.
Time Stamp
On, Off
Select “On” if you want the date & time (that
the image was captured) imprinted on every
photo/video, select “Off” for no imprint. Note:
the current temperature, moon phase, and (user
set) camera name will also be imprinted on your
still photos.
Video Sound
(Only affects
video clips in
Video mode)
On, Off
Select “On” to record audio along with the video
when the camera is set to video mode (saved
file sizes will be slightly larger).
Sensor Level
Auto, Low, Normal, High
Auto sensor level will automatically adjust the
sensor level depending on the surrounding