Model: 53-0021 Lit.
INTRODUCTION The Bushnell® Holosight® XLP is based on advanced holographic technology. The Bushnell® Holosight® XLP enhances target acquisition, improves accuracy, and provides a high level of control within the shooting environment. This user manual describes the features of the Bushnell® Holosight® XLP and provides information on its use and maintenance. Please read the instructions carefully before mounting and using the sight and always practice proper firearm safety.
FIGURE 1 2 BATTERIES Two (2) Type AAA alkaline 1.5 V batteries are required to operate the Bushnell® Holosight® XLP. The Bushnell® Holosight® XLP is designed to maintain constant brightness at a particular setting even as the batteries drain through normal use. The reticle brightness will not fade gradually as the batteries drain, but will shut down abruptly. The first indication of the batteries draining is the reticle image blinking when the unit is turned on (see Electronic Features Section).
polarity of the exposed contact of the battery. Check the polarity of the battery to be installed and insert the battery so that the opposite polarity end goes into the battery compartment. To re-install the battery cover, reverse the steps taken to remove the cover. DO NOT OVERTIGHTEN THE KNURLED SCREW. Secure it with finger tightness only. Verify correct battery installation by turning on the sight and checking that the reticle image appears.
To mount the sight to a Weaver-style rail, follow these steps, refer to Figure 3: 1. Loosen the 7/64” hex retainer screw that secures the clamp. 2. Place the sight onto the rail such that the unthreaded portion of the cross bolt is fitted into a groove on the top of the Weaver-style rail. The user’s preference and the firearm will determine the optimal front to back position on the rail. 3. With the cross bolt inserted fully into the rail’s groove, push the sight as far forward as possible. 4.
BORE SIGHTING AND ZEROING Bore sighting is a good preliminary procedure in achieving proper alignment of your sight to the firearm. If the sight is to be mounted to a Weaver-style rail, it is imperative that the base be parallel to the bore. Any major elevation adjustments may be accomplished by shimming the Weaver-style rail. It is important not to use the elevation adjustment of the sight for major adjustments.
MAINTENANCE AND CARE 1. The holographic image glass is coated with anti-reflection material. When cleaning the glass surfaces, first remove any dirt and dust with compressed air or by blowing on the glass surfaces. Fingerprints or lubricants can be wiped off with lens tissue or a soft cotton cloth, moistened with lens cleaning fluid or glass cleaner. Never clean the glass surface with a dry cloth or paper towel; always dampen the glass surfaces prior to cleaning. 2.
ENGLISH FCC COMPLIANCE The Bushnell® Holosight® XLP complies with Part 15b of the FCC Rules. Operation is subject to the following conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation.
©2005 Bushnell Performance Optics www.bushnell.