User Manual

5
SIGHTING IN/ZEROING YOUR AR OPTICS® SIGHT
WARNING! : SINCE THIS PROCEDURE INVOLVES LIVE FIRE, IT SHOULD BE DONE AT AN APPROVED RANGE
OR OTHER SAFE AREA. CHECK BORE FOR OBSTRUCTIONS. AN OBSTRUCTED BORE MAY CAUSE INJURY
TO YOU AND OTHERS NEAR BY. EYE & EAR PROTECTION IS RECOMMENDED.
ENRAGE/INCINERATE/TRS-26
1. With the sight mounted, rest the gun on a solid support. Switch on the sight’s power and adjust brightness as needed
until dot is easily visible.
2. Remove the windage and elevation adjustment caps.
3. Sight along the barrel and aim at a target 50 to 100 yards away. Sight through your AR Optics Red Dot and turn the
windage and/or elevation adjustments by hand to align the center dot with the target as seen along the barrel. Each
click of adjustment moves the point of impact by the amount written on the adjustments. Once the scope is zeroed,
replace the adjustment caps.
FIRST STRIKE 2.0
1. With the sight mounted, rest the gun on a solid support. Switch on the sight’s power and adjust brightness as needed
until dot is easily visible.
2. Start by sighting along the barrel and aim at a target 25 to 50 yards
away. View through your First Strike sight and gently rotate the
windage and/or elevation adjustments, using the supplied tool to
align the red dot with the target as seen along the barrel.
3. You should then re a test shot to determine the point of impact of
your weapon. If you are not hitting your aiming point (the center
of the target) make an adjustment by turning the windage or
elevation screw(s) in the direction you want the bullet to move. The
chart on the right will aid you in determining the proper amount of
adjustment necessary to change the point of impact, depending
upon the range at which you are shooting.
OPERATION UNDER EXTREME CONDITIONS
• Extreme heat (moist or dry): no special procedures required. Avoid prolonged exposure if possible.
• Extreme cold: extreme low temperature may shorten battery life. It could also make the rotary dial (brightness control)
on the Incinerate/Enrage a little harder to turn than at normal temperatures.
• Salt air: no special procedures required.
• Sea spray, water, mud and snow: ensure that battery cap and the two adjustment caps (if present) are tightened before
exposing the sight to sea spray, mud, snow or before immersing the sight in water. Hand tighten only. Keep lens covers
closed when sight is not being used. Clean lenses with lens paper/cloth (see caution note below) and wipe the sight dry
as soon as possible after exposure to water, sea spray, mud or snow.
• Dust storms and sand storms: keep lens covers closed when sight is not being used.
CAUTION: The lenses shall never be cleaned with ngers but with lens paper/cloth, to avoid scratching the glass.
Use a soft brush or “canned air” to remove any loose debris (sand, grass, etc.) prior to using the lens paper or soft clean cloth.
TROUBLE SHOOTING
Problem: Red Dot Does Not Appear
Possible Causes/Solutions:
• Discharged battery: Replace battery with a new CR2032 lithium cell.
• Battery installed incorrectly: Remove and reinstall battery, referring to the Parts Guide battery compartment image.
• Battery not making good contact: Clean contact surfaces and reinstall battery.
• Defective Rotary Switch: Contact Bushnell customer service.
Problem: Impossible To Zero
Possible Causes/Solutions:
• Adjustment screw is at its limit: Check alignment of mount to barrel.
• Impact point is moving: Check mount and weapon rail (or carry handle) stability.
Distance 1 Full Revolution of Adjustment Screw
25 yds 7.5 inches
50 yds 15 inches
100 yds 30 inches
Distance 1 Hash Mark of Adjustment Screw
25 yds .75 inches
50 yds 1.5 inches
100 yds 3 inches
Point of Impact Chart (First Strike 2.0)