Installation Manual

6710 N CATLIN AVE. • PORTLAND, OR 97203 • 503-283-4335 • 1-800-234-8920 (USA AND CANADA) • FAX [phone]
Rear Flare Installation Procedures (Driver’s Side):
40
Using a pry bar or claw hammer, remove the
christmas tree fasteners then remove/loosen the rear
wheel well skirting. Save fasteners for reinstallation.
39
Remove the factory installed fender fl are screws with
a 5/16” socket wrench. (8 locations)
Thoroughly clean the exposed metal fender with a
damp cloth then dry.
41 42
Locate the new fl at fl are rear inner pieces. The driver
side rear inner pieces are marked D3 and D4. The
passenger side rear inner pieces are marked P3 and
P4.
Screw
Washer
Put an M5-.8 machine screw (SW1-0053) and
washer (WA1-0003) through the top holes of the
inner pieces and secure with a 1/4” rubber spacer
(SP1-0011) on the underside of the inner piece.
43
Push the rubber spacer and M5-.8 machine screw
together until they are both tight against the inner
piece. Spacer has been lightened in picture for
visibility.
44