Installation Manual

6710 N CATLIN AVE. • PORTLAND, OR 97203 • 503-283-4335 • 1-800-234-8920 (USA AND CANADA) • FAX [phone]
Install a speed clip at each clip location on the inner
pieces, centering them on the predrilled holes. (6
locations) NOTE: Clips slide out of place easily. Try
pinching the metal tightly onto the inner piece with
pliers.
45
Install inner piece D3 (and P3 for passenger side
installation) by lining up the M5-.8 machine screws
(SW1-0053) with the factory hole locations and push
into place.
46
While holding the inner piece in place, use a #2
Phillips bit to tighten the M5-.8 machine screws
(SW1-0053) into the fl ange nuts (NU1-0010).
5049
Install inner piece D4 (and P4 for passenger side
installation) to the sheet metal by lining up the M5-
.8 machine screws (SW1-0053) with the factory hole
locations and push them into place.
Attach fl ange nuts (NU1-0010) into the threads on
the M5-.8 machine screws (SW1-0053) and hand
tighten.
NOTE: The two bolts on the bottom front of the
wheel well do not require nuts.
47 48