Installation Manual

6710 N CATLIN AVE. • PORTLAND, OR 97203 • 503-283-4335 • 1-800-234-8920 (USA AND CANADA) • FAX [phone]
Tube
feature
Inner
Underside
of Flare
Component List
Note: The edge trim for this application is double-
tape edge trim so special care needs to be taken
while installing. There is red vinyl backing on the
inside of the edge trim where it will adhere to the
fl are and red vinyl backing on the outside where it
will adhere to the vehicle. The following steps only
concern where the edge trim will adhere to the fl are.
Additional edge trim installation instructions are
included during the rest of the installation process.
A. Peel two to three inches of red vinyl
backing away from edge trim tape. Applying
the adhesive side of the edge trim to the inner
side of the fl are, affi x the edge trim to the top
edge of the fl are (the portion that comes in
contact with the vehicle). Stop at tube feature
of fl are. Picture 1 for tube feature reference
B. Press edge trim into place along the top edge
of the fl are in one-foot increments, pulling red vinyl
backing free as you continue to work your way
around the top edge of the fl are. Picture 2 for
additional edge trim orientation
NOTE: Edge trim (GP1-0006) will be installed on
the FLARES only, not the inner pieces.
Inner
Underside
of Flare
Picture 2
4 FRONT BRACKETS
4 REAR BRACKETS
2 ROCKER PANELS
2 REAR FLARES
2 FRONT FLARES