Installation Manual

6710 N CATLIN AVE. • PORTLAND, OR 97203 • 503-283-4335 • 1-800-234-8920 (USA AND CANADA) • FAX [phone]
1
Unplug the factory installed side marker lamp by
twisting the bulb housing in a counterclockwise
direction. This is located at the front of the factory
fl are on the backside in the wheel well.
Remove the factory installed fender fl are and rocker
guard screws with a 5/16” socket wrench. (13
locations on the backside of the fl are.)
2
Front Flare Installation Procedures (Driver’s Side):
Screw
Washer
Put an M5-.8 machine screw (SW1-0053) and
washer (WA1-0003) through the top holes of the
inner pieces and secure with a 1/4” rubber spacer
(SP1-0011) on the underside of the inner piece.
Locate the fl at fl are front inner pieces. The driver
side front inner pieces are marked D1 & D2. The
passenger side front inner pieces are marked P1 &
P2.
Remove the factory installed fender fl ares.
Thoroughly clean the exposed metal fender with a
damp cloth and dry.
6
3
5
Use wire cutters to cut the two wires at the base of
the factory side marker lamp.
4