Installation Manual

6710 N CATLIN AVE. • PORTLAND, OR 97203 • 503-283-4335 • 1-800-234-8920 (USA AND CANADA) • FAX [phone]
9
Use wire strippers to strip away approximately 3/8” of
wire covering from the factory installed side marker
lamp wires.
Install a Female Bullet Connector (EC1-0007) to
the end of each factory side marker light wires and
secure by pressing fi rmly with a wire crimp.
Seal with electrical tape or heat shrink tubing if
desired.
10
11 12
Secure inner piece D1 (and P1 for passenger side
installation) to the sheet metal using the following
Line up the M5-.8 machine screws (SW1-0053) with
the factory hole locations and push them into place.
Push the rubber spacer (SP1-0011) and machine
screw (SW1-0053) together until they are both tight
against the inner piece. Spacer has been lightened
in picture for visibility.
7
8
Install a speed clip (CL1-0022) at each clip location
on the inner pieces, centering them on the predrilled
holes. (7 locations) NOTE: Clips slide out of place
easily. Try pinching the metal tightly onto the inner
piece with pliers.