Installation Manual

6710 N CATLIN AVE. • PORTLAND, OR 97203 • 503-283-4335 • 1-800-234-8920 (USA AND CANADA) • FAX [phone]
Attach fl ange nuts (NU1-0010) to the threads on the
M5-.8 machine screws and hand tighten.
As you line up the inner piece, feed the wire harness
through the hole in the front of the bracket.
Install inner pieces D2 (and P2 for passenger side
installation) to the sheet metal by lining up the M5-.8
machine screws (SW1-0053) with the factory hole
locations.
Fully tighten fl ange nuts using a 5/16” socket and
wrench and use a #2 Phillips bit for the M5-.8
machine screws.
17
16
While holding the inner piece in place, use a #2
Phillips bit to tighten the M5-.8 machine screws
(SW1-0053) into the factory mounted nuts (NU1-
0010).
1413
15
Position the supplied side marker light (LT1-0003)
onto the outer fl are piece, threading the wires
through the center predrilled hole.
18