Owners manual

Toyota Scion TC
BUMPER PROTECTOR
AUTOMOTIVE GROUP
Bushwacker only approves installing the bumper protectors
according to these written instructions with the hardware provided.
WARNING: Failure to install according to these instructions will
invalidate the warranty. This includes, but is not limited to using
alternative installation methods, hardware, or materials. DO NOT
USE: Loctite, SuperGlue, or similar products on the bumper
protector.
Fit: Verify the fi t of the bumper protector to vehicle. (Some fi ling,
sanding, or cutting may be necessary to ensure proper fi t).
Painting: (Optional) if paint is desired it must be done prior to
installing bumper protector on the vehicle clean outer surface
with a good grade degreaser. DO NOT USE LACQUER
THINNER OR ENAMEL REDUCER AS A DEGREASER. Wipe
outer surface thoroughly with a tack rag prior to paint. Paint
bumper protector using a high quality enamel, or polyurethane
automotive paint. (Application of a primer coat is optional) If
painting edge trim (not recommended), use a fl ex additive.
Masking Tape
Nylon tool
Set Part #114003
Rev-4 03-25-10
STEP 1 - PRIOR TO INSTALLATION
TOOLS FOR EASY INSTALLATION:
•
•
A)
B)
C)
Edge Trim Tool
To claim a warranty, you must provide Proof
of Purchase.
INCLUDED IN KIT:
LIMITED LIFETIME WARRANTY AGAINST
ANY MANUFACTURING DEFECTS
•
•
Bumper Protector Installation Procedures
Apply a piece of masking tape along both edges of
part for ease of placement during installation.
Open rear door of vehicle. WITHOUT peeling liner
from tape pads, align part on bumper, centering the
center rib of the bumper protector with metal loop
on striker.
21
AUTOMOTIVE GROUP
4325 HAMILTON MILL RD • BUFORD, GA 30518 • 800-241-7219 (USA AND CANADA) • FAX [phone]
1